MacDon M150 SP - Manual (Page 45)

OPERATOR’S STATION
Form 169017 / 169087 / 169095
43
Revision C
DISPLAY WARNINGS AND ALARMS (Continued)
DISPLAY
FLAS
H
ING
ALARM TONE DESCRIPTION
IN PARK 9
One Short Beep.
GSL In N-Detent, Steering Wheel
Centered, And Brakes Are Engaged.
KNIFE SPEED OVERLOAD 9
Short Beep With Each Flash Until
Condition Is Corrected.
Machine Overload.
Knife Or Disc Speed Drops Below
Programmed Value.
LOCK SEAT BASE
Seat Base Not Detected In Cab Or
Engine-Forward Position.
LOW HYDRAULIC OIL 9
Continuous Loud Tone For 5
Seconds.
If Condition Not Rectified, Single
Loud Tone Every 5 Minutes.
Low Hydraulic Oil Level.
Header Shuts Down Automatically If
Engaged.
Header On Switch Must Be Moved
To OFF Position, And Then To ON
Position To Restart The Header.
NO HEADER None Header Is Not Detected.
NO OPERATOR Continuous Tone.
Operator Not Detected In Seat With
Header Engaged or Out Of Neutral
Detent.
Engine Shutdown After 5 Seconds.
NO OPERATOR
ENGINE SHUTDOWN
Continuous Tone.
Engine Shutdown When Operator
Not Detected In Seat With Machine
Moving Under 5 mph (8 km/h).
NOT IN PARK 9
Short Beep With Each Flash.
GSL or Interlock Switches Not
Closed With Key On/Engine Off.
PLACE GSL INTO “N”
Beeps At 2 Per Second Until
Corrected. GSL or Interlock Switches Not
Closed With Key On / Engine Off.
SLOW DOWN 9
Short Beep With Each Flash.
Ground Speed is Greater Than or
Equal to 25 mph (40 km/h).
Operator Should Pull Back on the
GSL to Reduce Ground Speed.
TRANS OIL PRESS 9
Continuous Loud Tone Until Oil
Pressure Is Regained. Low Transmission Charge Oil
Pressure.
TRANS OIL TEMP 9
Ongoing Intermittent Moderate
Tone Until Temperature Is Below
Acceptable Level.
Transmission Oil Temperature
Above 221°F (105°C).
##.# LOW VOLTS
9
Single Loud Tone For 10 Seconds. Voltage Below 11.5.
##.# HIGH VOLTS
9
Single Loud Tone For 10 Seconds. Voltage Above 16.