MacDon M150 SP - Manual (Page 223)

OPTIONS / ATTACHMENTS
Form 169017 / 169087 / 169095
221
Revision C
9 OPTIONS / ATTACHMENTS
9.1 REEL DRIVE AND LIFT PLUMBING
Reel drive and lift plumbing for draper headers on
windrowers that are shipped from the factory in
auger header configuration. Installation
instructions are included.
9.2 WINDROWER HYDRAULIC
COMPLETION FOR DRAPER
HEADER REEL FORE-AFT
Allows reel fore-aft hydraulic adjustment for draper
headers on windrowers that are shipped from the
factory in auger header configuration. Kit includes
valve for selection of reel fore-aft or double
windrow attachment functions. Installation
instructions are included.
9.3 DOUBLE WINDROW ATTACHMENT
Allows auger header windrower to lay a double
windrow. Installation instructions are included.
9.4 REVERSER VALVE AND
PLUMBING
Allows the header drive direction to be reversed
on both draper and auger headers to assist in
unplugging the header. With this option, all
components on the auger header can operate in
the opposite direction. On the draper header, only
the drapers, conditioner and knife are reversible.
Installation instructions are included.
9.5 BOOSTER SPRING KIT
Available for headers over 6000 lb (2724 kg).
Installation instructions are included.
9.6 INTERNAL BOOSTER SPRING KIT
Internal spring for right side lift linkage to improve
float capacity. Standard equipment on left side.
9.7 LIGHT HEADER FLOTATION KIT
Available for headers that do not require as much
spring tension for float. Installation instructions
are included.
9.8 WINDSHIELD SHADES
Retractable sun shades for front and rear
windows. Installation instructions are included.
9.9 DISC HEADER VALVE
Required for attaching a R80 Disc Header to
M150. Installation instructions are included.
9.10 AM/FM RADIO
Available for installation into pre-wired cab.
Speakers are factory installed.
Refer to M150 and M200 Self-Propelled
Windrower Unloading and Assembly Instructions
for installation instructions. This instructional
manual is supplied with your windrower.
9.11 CENTER-LINK SELF-ALIGNMENT
KIT
Available for M150 and M200 Windrowers
equipped with hydraulic center-link. Allows the
center-link cylinder to be hydraulically positioned
and connected to the header without leaving the
Operator’s station. Installation instructions are
included.
9.12 PRESSURE SENSOR KIT
Monitors hydraulic pressure and warns of overload
conditions. Installation instructions are included.
9.13 HYDRAULIC CENTER-LINK
The hydraulic center-link allows the operator to
adjust the header angle from the cab. It is
standard on the M200, and optional on the M150.
9.14 WEIGHT BOX
The weight box allows engine-forward transport in
high range when the header is not attached.
9.15 TOWING HARNESS
The towing harness is used together with the
weight box if towing a D Series draper header
behind the windrower is desired.
9.16 SWATH ROLLER
If a swath roller is desired for canola or other
similar crops, an axle mounted design is
recommended. Windrower can be fitted with
hydraulic lift version of swath rollers featuring in-
console controls.
(continued next page)