MacDon M150 SP - Manual (Page 90)

HEADER OPERATION - D SERIES
Form 169017 / 169087 / 169095
88
Revision C
6.5 D SERIES HEADER OPERATION
6.5.1 HEADER ATTACHMENT
IMPORTANT
To prevent damage to the lift system when
lowering header lift linkages without a
header or weight box attached to
windrower, ensure that float engagement
pin is installed in storage location (A), and
not installed at hole location (B).
a. If not installed, attach draper header boots
(supplied with header) to windrower lift linkage as
follows:
1. Remove pin (C) from boot (D).
2. Locate boot (D) on lift linkage (E), and reinstall
pin (C). Pin may be installed from either side
of boot.
3. Secure pin (C) with hairpin.
4. Repeat for opposite side.
b. Remove hairpin on pins (F), and remove pins from
header legs.
CAUTION
Check to be sure all bystanders have cleared
the area.
(continued next page)
D
E
C
F
B
A
C
D