Rockwell Automation 22F PowerFlex 4M User Manual FRN 1.xx - 2.xx - Manual (Page 39)

Start Up 2-5
PowerFlex 4M Adjustable Frequency Drive FRN 1.xx - 2.xx User Manual
Publication 22F-UM001D-EN-E
The Basic Program Group ( page 3-8 ) contains the most commonly changed parameters.
Step Key(s) Example Displays
6. Press Enter or Sel to view the value of a
parameter. If you do not want to edit the value,
press Esc to return to the parameter number.
7. Press Enter or Sel to enter program mode to
edit the parameter value. The rightmost digit will
flash and the Program LED will illuminate if the
parameter can be edited.
8. Press the Up Arrow or Down Arrow to change
the parameter value.
If desired, press Sel to move from digit to digit
or bit to bit. The digit or bit that you can change
will flash.
9. Press Esc to cancel a change. The digit will
stop flashing, the previous value is restored and
the Program LED will turn off.
Or
Press Enter to save a change. The digit will stop
flashing and the Program LED will turn off.
10. Press Esc to return to the parameter list.
Continue to press Esc to back out of the
programming menu.
If pressing Esc does not change the display,
then d001 [Output Frequency] is displayed.
Press Enter or Sel to enter the group menu
again.
or
or
or
VOLTS
AMPS
HERTZ
FAULT PROGRAM
VOLTS
AMPS
HERTZ
FAULT PROGRAM
VOLTS
AMPS
HERTZ
FAULT PROGRAM
VOLTS
AMPS
HERTZ
FAULT PROGRAM
VOLTS
AMPS
HERTZ
FAULT PROGRAM
VOLTS
AMPS
HERTZ
FAULT PROGRAM
VOLTS
AMPS
HERTZ
FAULT PROGRAM