Rockwell Automation 1783-Mxxx Stratix 8000 and 8300 Ethernet Managed Switches User Manual User Manual
Rockwell Automation Equipment
Advertising
Table of contents
Document Outline
- Stratix 8000 and 8300 Ethernet Managed Switches User Manual
- Important User Information
- Summary of Changes
- Table of Contents
- Preface
- 1 - Install the Switch
- Before You Begin
- Install the Switch
- Attach Expansion Modules (optional)
- Mount the Switch on a DIN Rail
- Mount the Switch on a Wall or Panel
- Install an SFP Module (optional)
- Ground the Switch
- Wire the DC Power Source for the Switch
- Wire the DC Power Source for the PoE Expansion Module (optional)
- Attach the Power and Relay Connector to the Switch
- Attach the Power Connector to the PoE Expansion Module (optional)
- Wire External Alarms (optional)
- Connect to 10/100 Copper Ports
- Connect to a PoE Expansion Module Port
- Connect to Dual-purpose Uplink Ports
- Connect to 100BaseFX Ports
- Install or Remove the CompactFlash Card
- Reset the Switch to Factory Defaults
- Troubleshoot the Installation
- 2 - Getting Started
- 3 - Switch Software Features
- Port Numbering
- Global Macro
- Smartports
- Power over Ethernet (PoE) Ports
- VLANs
- IGMP Snooping with Querier
- Spanning Tree Protocol
- Storm Control
- Port Security
- EtherChannels
- DHCP Persistence
- CIP Sync Time Synchronization (Precision Time Protocol)
- Resilient Ethernet Protocol
- SNMP
- Port Mirroring
- Layer 3 Routing (Stratix 8300 switch only)
- Static and Connected Routing
- Alarms
- Cryptographic IOS Software (optional)
- Cable Diagnostics
- Advanced Software Features
- 4 - Manage the Switch via the Device Manager Web Interface
- Access the Device Manager Web Interface
- Dashboard Overview
- Configure Smartports
- Configure Port Settings
- Configure Port Thresholds
- Configure EtherChannels
- Configure DHCP
- Configure VLANs
- Configure Power over Ethernet (PoE) Ports
- Configure PTP Time Synchronization
- Enable Static and Connected Routing
- Configure STP
- Configure REP
- Configure Port Security
- Configure IGMP Snooping
- Configure SNMP
- Configure Alarm Settings
- Configure Alarm Profiles
- Monitor Trends
- Monitor Port Statistics
- Monitor REP Topology
- Monitor CIP Status
- Diagnose Cabling Problems
- View System Log Messages
- Use Express Setup to Change Switch Settings
- Manage Users
- Reallocate Switch Memory for Routing
- Restart the Switch
- Upgrade the Switch Firmware
- Upload and Download Configuration Files
- 5 - Manage the Switch via the Studio 5000 Environment
- EtherNet/IP CIP Interface
- Add a Switch to the I/O Configuration Tree
- Configure Module Properties
- Connection Properties
- Switch Configuration Properties
- Port Configuration Properties
- Advanced Port Properties
- Port Thresholds (storm control)
- Monitor and Reset the Switch
- Switch Status
- Port Status
- Port Diagnostics
- Cable Diagnostics
- DHCP Pool Display
- DHCP Address Assignment
- Time Sync Configuration
- Time Sync Information
- Save and Restore Switch Configuration
- 6 - Troubleshoot the Switch
- A - Status Indicators
- B - I/O Data Types
- C - Port Assignments for CIP Data
- D - Cables and Connectors
- E - History of Changes
- Index
- Back Cover