Rockwell Automation 1783-Mxxx Stratix 8000 and 8300 Ethernet Managed Switches User Manual - Manual (Page 90)

90 Rockwell Automation Publication 1783-UM003I-EN-P - March 2014
Chapter 4 Manage the Switch via the Device Manager Web Interface
EIP Net The EIP Net status indicator shows the network status of the switch.
Off Power to the switch is off or is not properly connected.
Solid green The switch has an established CIP connection to one or more attached devices.
Blinking green The switch has an IP address but the switch does not have an established connection to one or more attached
devices.
Blinking red One or more connections to attached devices have timed out.
Solid red The switch has detected that its IP address is already in use by another device in the network.
Blinking green and red The switch is running its power-on self-test (POST).
Setup The Configuration mode in which the switch is operating.
Off The switch is configured as a managed switch or the switch is operating as an unmanaged switch.
Blinking green Switch is in the initial Setup mode or is in the Direct Managed mode, or the initial setup is incomplete.
Pwr A and Pwr B The Pwr status indicators show the DC power status.
Off Power to the switch is off or is not properly connected.
Solid green Power is present.
Solid red Power to the switch is not present and the power alarm is on.
Table 5 - System-level Status Indicators (continued)
Indicator Status Description
Table 6 - Port-level Status Indicators
Indicator Status Description
Status In this mode, the port status indicators show the status of the ports. This is the default mode.
Off No link
Solid green No activity on link.
Flashing green Link activity.
Solid brown Port has been disabled.
Yellow An error has disabled the port.
Flashing green and
amber Faulty link.
Status Flashing amber Smartports configuration mismatch on port.
Solid amber Port is faulty, disabled due to an error, or is in an STP-blocked state.
Duplex In this mode, the port status indicators show the Duplex mode (Full-duplex or Half-duplex) of the ports.
The 10/100/1000 ports operate only in Full-duplex mode.
Off No link.
Solid light blue Port is in Half-duplex mode.
Solid green Port is in Full-duplex mode.
Speed In this mode, the port status indicators show the operating speed (10, 100, or 1000 Mbps) of the ports.
Off No link.
Solid light blue 10 Mbps
Solid green 100 Mbps
Flashing green 1000 Mbps
Smartports In this mode, each port image shows the applied port role.