Rockwell Automation 1783-Mxxx Stratix 8000 and 8300 Ethernet Managed Switches User Manual - Manual (Page 108)

108 Rockwell Automation Publication 1783-UM003I-EN-P - March 2014
Chapter 4 Manage the Switch via the Device Manager Web Interface
Assign Ports to VLANs
To assign ports to VLANs, use the Edit Physical Ports window, as described on
page 98 .
Configure Power over
Ethernet (PoE) Ports PoE and PoE+ features are supported when the switch has a PoE expansion
module installed and a correct power supply is connected to the switch. For
power supply requirements, see
page 31 .
If a PoE expansion module is connected to the switch, you can do the following
from the PoE window:
• View the PoE status of connected PoE expansion modules.
• Limit the total power supported.
• Configure mode and power settings for individual ports.
For most applications, the default configuration (Auto mode) is sufficient and no
further configuration is required. However, you can customize the settings to
meet your needs. For example, to give a PoE port higher power priority, set the
mode to Static and allocate the power to be used. As another example, to disallow
high-power devices on a port, set the mode to Auto and specify a maximum
power limit.