Reallocate switch memory for routing – Rockwell Automation 1783-Mxxx Stratix 8000 and 8300 Ethernet Managed Switches User Manual User Manual
Page 136
136
Rockwell Automation Publication 1783-UM003I-EN-P - March 2014
Chapter 4 Manage the Switch via the Device Manager Web Interface
Reallocate Switch Memory
for Routing
Switch Management Database (SDM) templates optimize how switch memory is
allocated for specific features, such as routing. To enable static and connected
routing, you must change the default SDM template to the Lanbase Routing
template.
To apply an SDM template, follow these steps.
1. From the Admin menu, choose SDM-Template.
2. Choose a template from the pull-down menu:
• Default—Gives balance to all Layer 2 functions
• Lanbase Routing—Maximizes system resources for IPv4 unicast
routing, which is required to enable routing
• Unknown—User-configured from the CLI
3. Click Submit.
4. When a message appears prompting you to continue, click OK.
A message appears once the process is complete.
5. To enable routing, proceed to
Enable Static and Connected Routing on
IMPORTANT
The process of changing the template causes the switch to
automatically restart.