Rockwell Automation 1783-Mxxx Stratix 8000 and 8300 Ethernet Managed Switches User Manual - Manual (Page 34)

34 Rockwell Automation Publication 1783-UM003I-EN-P - March 2014
Chapter 1 Install the Switch
Follow these steps to connect the DC power source and relay connector to the
switch.
1. Insert the power and relay connector into the Pwr A receptacle on the
switch front panel.
2. Use a screwdriver to tighten the captive screws on the sides of the power
and relay connector.
3. If a second power source is required, insert a second power and relay
connector into the Pwr B receptacle on the switch front panel.
.
4. Use a screwdriver to tighten the captive screws on the sides of the second
power and relay connector.
ATTENTION: If multiple power sources are used, do not exceed the
specified isolation voltage
VR
T
A
A
31786-M
VR T A A
31788-M
VR
T
A
A