Rockwell Automation 1783-Mxxx Stratix 8000 and 8300 Ethernet Managed Switches User Manual - Manual (Page 27)

Rockwell Automation Publication 1783-UM003I-EN-P - March 2014 27
Install the Switch Chapter 1
Install an SFP Module
(optional)
Grasp the module on the sides, and insert it into the switch slot until you feel the
connector snap into place.
ATTENTION: Under certain conditions, viewing the small form-factor
pluggable (SFP) optical transceiver may expose the eye to hazard. When
viewed under some conditions, the optical port may expose the eye beyond the
maximum permissible exposure recommendations.
ATTENTION: SFP modules are static sensitive devices. Always use an ESD wrist
strap or similar individual grounding device when handling SFP modules.
WARNING: When you insert or remove the small form-factor pluggable (SFP)
optical transceiver while power is on, an electrical arc can occur. This could
cause an explosion in hazardous location installations.
IMPORTANT Using an SFP module other than those provided by Rockwell Automation will
disable the switch port.
IMPORTANT Installing and removing an SFP module can shorten its useful life. Do not
remove and insert SFP modules more often than is absolutely necessary.
ATTENTION: If the SFP module cannot be fully inserted, stop! Do not force the
module into the slot. Rotate the SFP module 180 degrees and try again.
31782-M