Rockwell Automation 1783-Mxxx Stratix 8000 and 8300 Ethernet Managed Switches User Manual User Manual
Page 23
Rockwell Automation Publication 1783-UM003I-EN-P - March 2014
23
Install the Switch Chapter 1
Follow these steps to connect the expansion modules to the switch.
1. Remove the right side panel by firmly grasping both sides of it in the
middle and pulling it outward.
If necessary, use a screwdriver to pry open the side panel.
2. Remove the protective EMI-connector cover from the side panel.
3. Push the upper module latches up and the lower module latches down.
Then slide the switch and module together.
The expansion module is shown with the side panel removed. Do not
remove this panel unless you plan to install another module.
IMPORTANT
You must add expansion modules to the base unit before applying power to
the switch. Remove power from the switch when reconfiguring it.
31779-M
31787-M
31780-M