Rockwell Automation 1783-Mxxx Stratix 8000 and 8300 Ethernet Managed Switches User Manual - Manual (Page 39)

Rockwell Automation Publication 1783-UM003I-EN-P - March 2014 39
Install the Switch Chapter 1
Connect to 100BaseFX Ports
1. Insert a fiber-optic cable with an LC connector into the 100BASE-FX
port of the 1783-MX08F expansion module.
2. Insert the other cable end into the other device.
Install or Remove the
CompactFlash Card The switches ship with the CompactFlash card installed. Follow this procedure
when you need to install or remove it from the switch.
Install or remove the CompactFlash card by grasping the tab on the card and
either inserting it or removing it from the slot at the bottom of the switch.
ATTENTION: Class 1 laser product. Laser radiation is present when the system is
open and interlocks bypassed. Only trained and qualified personnel are allowed
to install, replace, or service this equipment.
31797-M
WARNING: When you insert or remove the CompactFlash Card while power is
on, an electrical arc can occur. This could cause an explosion in hazardous
location installations. Be sure that power is removed or the area is
nonhazardous before proceeding.
IMPORTANT You can install and remove the CompactFlash card while the switch is powered.
However, if you do not have a CompactFlash card installed in the switch, you
are unable to do the following:
• Start the Device Manager Web interface when you apply power to the
switch.
• Save configuration changes you made with the AOP via software.
• Start up the switch.
VR
T A
A
31792-M