Rockwell Automation 1783-Mxxx Stratix 8000 and 8300 Ethernet Managed Switches User Manual - Manual (Page 91)

Rockwell Automation Publication 1783-UM003I-EN-P - March 2014 91
Manage the Switch via the Device Manager Web Interface Chapter 4
You can change the port status indicator behavior by choosing a Port mode from
the View list on the Front Panel view.
Move the pointer over a port to display specific information about the port and
its status.
Note the following:
• The speed and Duplex mode for a port appear only in the pop-up dialog
box when a device is connected to the port.
• For dual-purpose ports, the Type field in the pop-up dialog box displays
10/100/1000BaseTX for the copper uplink port whether or not the port
is active. The Type field also displays either the type of SFP module
installed or Empty if a module is not installed.
• The Smartport type and VLAN type and name appear when Smartport
Port mode is selected.
• The Uptime field shows how long the switch has been operating since it
was last powered on or was restarted. Status is automatically refreshed
every 60 seconds or when you click Refresh. The refresh counter shows the
number of seconds that remain before the next refresh cycle starts.
TIP If you move the pointer over a port that is blinking green and amber, the status
is one of the following:
• Link is faulty.
• Link has collisions.
In either state, the port is receiving and sending traffic.