Rockwell Automation 1747-SCNR ControlNet Scanner Module Reference Manual - Manual (Page 106)

Publication 1747-RM623D-EN-P - June 2006
E-28 Application Examples
Note that your ladder program should also contain an
unconditional rung with an OTE instruction addressed to the
1747-SCNR scanner’s Run/Idle bit, O:3.0/10 for this example.
When the SLC processor is placed into the Run mode, this rung
will set the 1747-SCNR scanner’s Run/Idle bit and place the
scanner into the Run mode as well. The scanner will begin
executing the configured connections when the Run/Idle bit is
set.
Example 4: Configure the
1747-SCNR Scanner with
the 1746-BAS Series B
Interface Module The following example discusses how to configure the 1747-SCNR
scanner with the 1746-BAS Series B interface module.
Hardware Setup
The hardware setup for this examples includes a computer with
RSLogix500, RSLinx, RSNetWorx for ControlNet software, and a
1784-KTCX15 interface card.
The chassis configuration includes a 1747-ACNR15 module in slot 0,
1746-IA16 module in slot 1, 1746-OB16 module in slot 2, and
1746-BAS module in slot 3.