Rockwell Automation 1747-SCNR ControlNet Scanner Module Reference Manual - Manual (Page 82)

Publication 1747-RM623D-EN-P - June 2006
E-4 Application Examples
If the chassis is not already configured, manually configure it by
dragging the appropriate modules from the list on the right to
the proper slot on the left of the chassis configuration screen.
When this is complete, click APPLY and then OK.
Configure a Rack Connection
We are now ready to configure the necessary ControlNet connection
so we can read/write data from the SLC processor to the remote
discrete I/O modules.
1 . Click-right the 1747-SCNR scanner and choose Scanlist
Configuration.
You see a prompt to enter the Edit mode.
2. Click YES to see the following screen:
The 1747-SCNR scanner and 1747-ACNR15 module are shown as
nodes 1 and 3, respectively.
The three I/O modules are under the 1747-ACNR15 module in
slots 1 through 3 of the 1747-ACNR15 chassis.
3. To establish a 16-bit rack connection to the 1747-ACNR15
chassis, click-right the 1747-ACNR15 module and choose Insert
Connection.