Rockwell Automation 1763 MicroLogix 1100 Programmable Controllers User Manual - Manual (Page 123)

Publication 1763-UM001D-EN-P - March 2011
Using the LCD 121
5. We will change the data value of the N7:0 word to the negative decimal
value -1300. First, press OK to move the cursor to the data value
position. Then, the last digit of “+00000” will be flashing, which means
the cursor is at the data value position.
6. Press the Left key twice. Then, the cursor will position at the third digit.
Press the Up key three times to change the third digit to 3.
7. Press the Left key once. Then, press the Up key once. The second digit
will change to “1”. Note that “1” is still flashing, which means the
cursor is still at the data value position.
8. Press the Left key once. Then, press the Down key once. The sign digit
will change to “-”, as shown below. Note that “-” is still flashing, which
means the cursor is still at the data value position.