Panel mounting – Rockwell Automation 1763 MicroLogix 1100 Programmable Controllers User Manual User Manual
Page 38
Publication 1763-UM001D-EN-P - March 2011
36 Installing Your Controller
Panel Mounting
Mount to panel using #8 or M4 screws. To install your controller using
mounting screws:
1. Remove the mounting template from inside the back cover of the
MicroLogix 1100 Programmable Controllers Installation Instructions,
publication 1763-IN001.
2. Secure the template to the mounting surface. (Make sure your controller
is spaced properly. See Controller and Expansion I/O Spacing on page
33.)
3. Drill holes through the template.
4. Remove the mounting template.
5. Mount the controller.
6. Leave the protective debris shield in place until you are finished wiring
the controller and any other devices.
ESC
OK
open
closed
Mounting Template
(Remove before
installing controller)
Debris Shield