Rockwell Automation 1763 MicroLogix 1100 Programmable Controllers User Manual - Manual (Page 99)

Publication 1763-UM001D-EN-P - March 2011
Communication Connections 97
Connecting to DeviceNet You can connect a MicroLogix™ 1100 as a slave to a DeviceNet network
using the DeviceNet Interface (DNI), catalog number 1761-NET-DNI. For
additional information on using the DNI, refer to the DeviceNet Interface User
Manual, publication 1761-UM005. The following figure shows the external
wiring connections of the DNI.
Cable Selection Guide
(1)
(1) Series C (or later) cables are required.
V–
CAN_L
SHIELD
CAN_H
V+
NET
MOD
NODE
DANGER
GND
TX/RX
DeviceNet Node (Port 1)
(Replacement connector
part no. 1761-RPL-RT00)
Use this write-on
area to mark the
DeviceNet node
address.
RS-232 (Port 2)
1761-CBL-AM00
1761-CBL-HM02
Cable Length Connections from to DNI
1761-CBL-AM00
1761-CBL-HM02 45 cm (17.7 in.)
2 m (6.5 ft) MicroLogix 1000 port 2
MicroLogix 1100 port 2
MicroLogix 1200 port 2
MicroLogix 1500 port 2
1761-CBL-AP00
1761-CBL-PM02
Cable Length Connections from to DNI
1761-CBL-AP00
1761-CBL-PM02 45 cm (17.7 in.)
2 m (6.5 ft) SLC 5/03 or SLC 5/04 processors,
channel 0 port 2
PC COM port port 2
1764-LRP processor, channel 1 port 2