Rockwell Automation 2500 CENTERLINE Motor Control Centers Installation Manual - Manual (Page 12)

12 Rockwell Automation Publication 2500-IN001C-EN-P - April 2014
Chapter 1 System Overview
IntelliCENTER Software CENTERLINE 2500 MCCs with IntelliCENTER software provides you with
an integrated hardware, software, and communication solution. It features
preconfigured software that provides real-time data, trending, component
history, wiring diagrams, user manuals, and spare parts. IntelliCENTER offers
plug-and-play setup, troubleshooting, hardware configuration changes without
opening enclosure doors, and convenient change tracking. It also provides
intelligent diagnostic and predictive failure information.
IntelliCENTER technology improves the intelligence of your MCC by using
built-in networking to capture information used for predictive maintenance,
process monitoring, and advanced diagnostics.
IntelliCENTER Features
• Built-in networking
–
EtherNet/IP or DeviceNet
– Media protected behind barriers
– Access ports in wireways
– Topology lets you add and remove devices without interrupting any
other device on the network
• Intelligent motor controls
–
PowerFlex® drives
– SMC™-3 and SMC-Flex soft starters
– E300, E1 Plus™, and E3 Plus™ electronic overload relays
• IntelliCENTER software
–
Distributed IO
– POINT I/O™ system/DSA
– Virtual MCC
– Parameter editor
– Status dashboards
– Documentation management
– Spare parts information
• Factory configuration
–
IP address network media validation
– IP address node configuration
– Communication check
– Network commissioning