Rockwell Automation 2500 CENTERLINE Motor Control Centers Installation Manual - Manual (Page 21)

Rockwell Automation Publication 2500-IN001C-EN-P - April 2014 21
Chapter
2
Receiving, Handling, and Storage
Refer to Receiving, Handling and Storing CENTERLINE 2500 Motor Control
Centers Instructions, publication
2500-IN002 , for additional instructions. This
publication is shipped with each MCC, attached to the outside of the MCC
within the layer of clear poly wrap.
Receiving CENTERLINE 2500 MCCs are shipped upright as one or two column shipping
blocks or two or four double front column shipping blocks. Each
CENTERLINE 2500 MCC shipping block is provided with a lifting angle. Each
column in a shipping block is bolted to the shipping skid with removable
shipping angles and covered with clear plastic wrap. Protection is for upright
shipping and is not waterproof or watertight. Equipment that extends from the
structures is also protected.
Heavy duty/export packaging is similar to standard packaging, but uses a poly
wrap suitable for occasional water-spray. In addition, wood framing and sheeting
surround the columns. Heavy duty/export packaging is not watertight,
waterproof, or intended for long-term storage.
Upon delivery of the MCC, refer to the packing slip shipped with your MCC for
sizes and exact shipping weights, as well as the shipment for lost or damaged
items. If lost or damaged items are detected, refer to the steps described in
publication
2500-IN002 .
ATTENTION: To avoid personal injury or structural damage, never attempt to
lift or move the motor control center by any means other than the methods
outlined in the Receiving, Handling and Storing CENTERLINE 2500 Motor Control
Centers Instructions, publication
2500-IN002 . Motor control centers are top and
front heavy.