Rockwell Automation 2500 CENTERLINE Motor Control Centers Installation Manual - Manual (Page 27)

Rockwell Automation Publication 2500-IN001C-EN-P - April 2014 27
Install Columns Chapter 3
Removing the Covers
Follow these procedures for removing the covers on the MCC.
1. Remove the top and bottom horizontal wireway covers from the MCC.
2. If present, remove the top, bottom, and center end closing plates, on the
sides of the two columns that are to be joined.
3. If ArcShield is present, remove the center end closing plate insulators.
For more information, refer to Chapter 4 .
IMPORTANT When planning MCC cable routing, consider cable replacement in your
plans.
Top End
Closing Plates
Horizontal
Wireway Covers
Center End Closing Plate
Insulator (optional)
Bottom End
Closing Plates
Center End
Closing Plates
Horizontal
Wireway Covers