Rockwell Automation 2500 CENTERLINE Motor Control Centers Installation Manual - Manual (Page 51)

Rockwell Automation Publication 2500-IN001C-EN-P - April 2014 51
Door Latches, Operator Handles, and Unit Interlocks Chapter 5
Small Rotary-operator
Handles The following is a brief summary of operating instructions for small rotary-
operator handles. For additional information, see publication
21-361-950-01 ,
which is available online at http://www.rockwellautomation.com/literature .
Figure 17 - Small Rotary-operator Handle Positions
Opening the Unit Door
1. Turn the small rotary-operator handle to the OFF/O position.
2. Release the door latches.
3. Grasp the small rotary-operator handle and pull the unit door toward you
to open.
Closing the Unit Door
1. Check that the small rotary-operator handle is in the OFF/O position.
2. Close the unit door.
3. Secure the door latches.
Handle in OFF/O Position Handle in ON/I Position Handle in Tripped/T Position