Rockwell Automation 2500 CENTERLINE Motor Control Centers Installation Manual - Manual (Page 13)

Rockwell Automation Publication 2500-IN001C-EN-P - April 2014 13
System Overview Chapter 1
IntelliCENTER Software
IntelliCENTER MCCs can be provided with pre-configured IntelliCENTER
software. The software is capable of viewing, managing, and configuring multiple
MCC line-ups. The IntelliCENTER software communication driver lets the
software be installed and operated on EtherNet/IP or DeviceNet. The
IntelliCENTER software can function as a stand alone software package or as an
ActiveX control in a human machine interface (HMI).
Structure CENTERLINE 2500 MCCs offer units with a full complement of AC drives,
soft starters, and other devices. Pluggable power connections on the back of the
unit plug into the vertical bus. A mechanical interlock helps prevent the unit
door from being opened while the main switch is in the ON/I position. An
additional mechanical interlock helps prevent the unit from being withdrawn or
inserted when the unit main switch is closed. Separate vertical wireways isolate
control and network cables from power wiring. Units are available as fixed or
fully withdrawable.
Figure 1 - CENTERLINE 2500 MCC