Figure 29, For mo – Rockwell Automation 2500 CENTERLINE Motor Control Centers Installation Manual User Manual
Page 85
Rockwell Automation Publication 2500-IN001C-EN-P - April 2014
85
IntelliCENTER Options
Chapter 9
Figure 29 - Installing Terminating Resistors and DeviceNet Splicing Cables
Terminating
Resistor
DeviceNet cable is
spliced between
MCC columns.
Terminating
Resistor
Removable horizontal
wireway cover at top
of MCC column.
DeviceNet
Linking
3-phase Horizontal
Power Bus
NOTE: Examples at right depict typical 2500 MCC
configurations with one DeviceNet network.
Refer to
for examples of typical 2500 MCC
configurations with two DeviceNet networks.
Trunk line in the
control and
network wireway.
DeviceNet ports
are supplied for
each required unit.
DeviceNet trunk cable routing
through typical MCC column.
DeviceNet
Scanner
DeviceNet
Scanner
Power
Flex
Drive
MCC configuration
with a remote
DeviceNet scanner.
Configuration with
remote DeviceNet
scanner and divided
MCC line-up.
Each DeviceNet trunk line
must start and end with
a terminating resistor.
MCC configuration with
DeviceNet scanner
installed in a fixed unit.
MCC configuration with
remote DeviceNet scanner
and remote device.
DeviceNet port behind top horizontal wireway cover.
Remote
DeviceNet
Scanner