Rockwell Automation 2500 CENTERLINE Motor Control Centers Installation Manual - Manual (Page 25)

Rockwell Automation Publication 2500-IN001C-EN-P - April 2014 25
Install Columns Chapter 3
Remove Packing Materials When the MCC has been delivered to the site of installation, remove the
packaging material. Save any manuals and data sheets for future reference.
1. Remove the packing box around the horizontal bus if present and remove
the four brackets as shown (Detail A).
2. Remove the bolts securing each shipping angle (Detail B) from the
shipping skid.
3. Remove the shipping angles from the MCC.
You can now remove the MCC from the shipping skid.
ATTENTION: To avoid personal injury, use caution when the motor control
center is not secured. Motor control centers are top and front heavy.
Shipping Angle
(4 places)
Packing Box Brackets
(4 places)
Detail A
Detail B
B
A
ATTENTION: Once the bolts are removed from the shipping angles, the
MCC is no longer secured on the skid.