Rockwell Automation 2500 CENTERLINE Motor Control Centers Installation Manual - Manual (Page 26)

26 Rockwell Automation Publication 2500-IN001C-EN-P - April 2014
Chapter 3 Install Columns
Locating Bus Splice Kits
Power bus splice kits, if required, are within a wireway or blank unit space. A
fluorescent pink, removable label (on the outside of the column) designates the
location. PE splice kits are in the bottom horizontal wireway, fastened to the
horizontal PE conductor.
Locate the splice kits and set aside for later use.
Figure 10 - Splice Kit Label