Rockwell Automation FactoryTalk Historian SE 3.01 Installation and Configuration Guide - Manual (Page 104)

Chapter 6 Configuring FactoryTalk Historian
104 Rockwell Automation Publication HSE-IN024A-EN-E–December 2012
• PITagCnf.xla
• for MDB Builder:
...\Program Files (x86)\Rockwell Software\FactoryTalk
Historian\PIPC\MDBBuilder\:
• MDBBuilder.xla
7. Click OK after selecting each file. The file is added to the
Add-Ins available list.
8. Click OK to close the dialog box. The tabs with the selected
Excel Add-ins are added to the ribbon.
FactoryTalk Historian SE uses the FactoryTalk Diagnostics
component of the FactoryTalk Services Platform to record messages
sent by the FactoryTalk Historian SE server. In the event of a
message, the FactoryTalk server logs it in the FactoryTalk
Diagnostics service.
If the FactoryTalk Historian SE server cannot connect to the
FactoryTalk Diagnostics service, the server will log the messages in
the Windows Event log and continue to reconnect to FactoryTalk
Diagnostics service. Once the server reconnects to the FactoryTalk
Diagnostics service, a message is logged indicating that some
messages may not have been logged and will advise you to check the
local Windows Event log.
Each message logged to the FactoryTalk Diagnostics service contains
the following information:
Item name Description
Date/Time The date and time the message was recorded. The time is the local
time for the server. This is important to note if you are in a different
time zone than the server.
Recording Messages Using
FactoryTalk Diagnostics
Message Parameters