Rockwell Automation FactoryTalk Historian SE 3.01 Installation and Configuration Guide - Manual (Page 39)

Installing FactoryTalk Historian Chapter 4
Rockwell Automation Publication HSE-IN024A-EN-E–December 2012 39
NOTE
See "Add the AF Service Computer to the AFServer Group
55" for more information.
The Installation Progress page appears. It lists the
components that are going to be installed. The status of the
installation is displayed in the Status column of the
component table.
10. Click Install to start the installation.
11. Wait until the components are installed. The installation time
will vary depending on the selected installation mode and the
computer performance. The installation status is displayed on
the progress bar below the component table.
12. On the Installation Wizard Completed page, click Show the
installation log, if you want to view the installation log after
the installation wizard closes.
13. Click Finish to exit the installation wizard.
The FactoryTalk Historian SE server is installed with the following
FactoryTalk Historian components:
• FactoryTalk Historian server
• FactoryTalk Historian Live Data Interface
• Historian Interface Configuration Utility (ICU)
• RA Components
• FactoryTalk Activation Manager
Install FactoryTalk
Historian SE Server