Rockwell Automation FactoryTalk Historian SE 3.01 Installation and Configuration Guide - Manual (Page 123)

Configuring Historian Servers in High Availability Mode Appendix A
Rockwell Automation Publication HSE-IN024A-EN-E–December 2012 123
If the server collective is not listed in the Connection
Manager, add it:
1. Select Server > Add Server.
2. In the Network Node text box, type the fully qualified
domain name (FQDN) for the primary server in the
collective.
3. Click OK.
3. Select the server collective.
4. Click Save to close the Connection Manager.
2. Under Collectives, select your server collective.
The right pane of the dialog box displays the current status of
the connection between the members of the selected server
collective. The Collective Manager shows a diagram of server
collective members. An icon represents each server in the
collective. A green check mark on the icon indicates that the
server is communicating correctly. A red x mark indicates that
the server is not communicating correctly.
If a server icon is not communicating correctly, you can:
• Wait a few moments. Occasionally, the status of the
secondary server will get updated at the next attempt to
synchronize.
• Try to reinitialize the server. To do so, right-click the server
icon and select Reinitialize Server.