Rockwell Automation FactoryTalk Historian SE 3.01 Installation and Configuration Guide - Manual (Page 32)

Chapter 4 Installing FactoryTalk Historian
32 Rockwell Automation Publication HSE-IN024A-EN-E–December 2012
The system checks if you have all the required components
installed. If any components are missing, a dialog box appears
prompting you to install the missing components. Click OK.
The installation wizard appears.
3. On the Welcome page, click Next.
4. On the License Agreement page, read and accept the terms of
the license agreement, selecting the I accept... option.
Click Next.
5. On the Setup Type page, select Standard Feature Set
Installation, and click Next.
6. On the Ready to Install the Program page, click Install to
start the installation.
The Installing... page appears with the status of the
installation.
7. In the Windows Security dialog box, select Always trust
software from "Rockwell Automation", and click Install to
proceed with the installation of the software.
8. On the InstallShield Wizard Completed page:
• Clear the check box next to Review Release Notes, if you
do not want to have them displayed.
• Click Finish to exit the wizard.
In this section you will find instructions on how to install the
following suites of FactoryTalk Historian SE:
• FactoryTalk Historian Asset Framework (page 33)
• FactoryTalk Historian SE Server (page 39)
• (Optional) FactoryTalk Historian Live Data Interface (page
43)
Applicable only to the customers who want to install the
interface on a remote computer.
Installing FactoryTalk
Historian Suites