Rockwell Automation FactoryTalk Historian SE 3.01 Installation and Configuration Guide - Manual (Page 40)

Chapter 4 Installing FactoryTalk Historian
40 Rockwell Automation Publication HSE-IN024A-EN-E–December 2012
NOTE
The FactoryTalk Historian SE Server must be installed on Microsoft
Windows Server 2008 R2 with Service Pack 1 64-bit. If you try to
install it on any other operating system, the message presented
below will appear and the installation will be aborted.
To install the FactoryTalk Historian SE server:
1. Run the FactoryTalk Historian SE installation DVD.
2. On the welcome page of the installation wizard, click
Install
FactoryTalk Historian SE > Install FactoryTalk Historian
Server.
The installation wizard appears.
If there are any software prerequisites missing from the
computer, they are listed in red at the bottom of the
installation wizard Welcome page. Click Cancel and Finish
to exit the wizard, install the prerequisites, and start the
installation wizard again.
3. On the Welcome... page, click Next.
4. On the License Agreement page, read and accept the terms of
the license agreement, selecting the I accept... option.
5. Click Next.
6. On the Customer Information page, type your user name,
organization, and the 10-digit product serial number, e.g.
0123456789.