Rockwell Automation FactoryTalk Historian SE 3.01 Installation and Configuration Guide - Manual (Page 113)

Troubleshooting FactoryTalk Historian Chapter 7
Rockwell Automation Publication HSE-IN024A-EN-E–December 2012 113
Message Due to the lack of connection to the network, some of the
FactoryTalk Historian components have not been correctly
configured.
Cause The warning occurs if you try to create new folders in the
FactoryTalk Directory when your client computer is not connected
to the network.
Resolution Manually create a connection to the FactoryTalk Directory and add
folders. See the instruction below.
To add the schema information to the FactoryTalk Directory, we
recommend that you execute the FTHMESecurityUpdate.bat file.
It is located in the Redist\FTHME Security directory on your
FactoryTalk Historian SE installation DVD. The file automatically
adds schema information and folders to the FactoryTalk Directory
on your client computer.
To manually add folders to the FactoryTalk Directory:
Open the Command Prompt window and type the following:
"[ProgramFilesFolder]Rockwell Software\Management
Tools\FTHistorianInstallSetup.exe"
"[CommonAppDataFolder]Rockwell Automation\FactoryTalk
Historian\FTHistorianFolders.xml" -G
Where:
• [ProgramFilesFolder] is the Program Files (x86) directory
(e.g. c:\Program Files (x86)).
• [CommonAppDataFolder] is the ProgramData directory (e.g.
c:\ProgramData) on your client computer.
Folders Creation