Rockwell Automation FactoryTalk Historian SE 3.01 Installation and Configuration Guide - Manual (Page 116)

Chapter 7 Troubleshooting FactoryTalk Historian
116 Rockwell Automation Publication HSE-IN024A-EN-E–December 2012
For this
FactoryTalk
Historian suite: Run these commands:
Asset Framework %COMMONFILESFOLDERX86%\Rockwell\WFCU\wfcu.exe -I
"%COMMONFILESFOLDERX86%\Rockwell\WFCU\FTHistoria
nSEAF.wfcu"
Historian Server %COMMONFILESFOLDERX86%\Rockwell\WFCU\wfcu.exe -I
"%COMMONFILESFOLDERX86%\Rockwell\WFCU\FTHistoria
nSEServer.wfcu"
Live Data Interface %COMMONFILESFOLDERX86%\Rockwell\WFCU\wfcu.exe -I
"%COMMONFILESFOLDERX86%\Rockwell\WFCU\FTHistoria
nSELiveDataInterface.wfcu" -s
The %COMMONFILESFOLDERX86% variable stands for
the location of the Common Files folder on the computer.
Example: If the Common Files folder is in the following
location:
C:\Program Files\Common Files\
The complete path to the command that you need to run for
the Historian to Historian Interface is:
C:\Program Files\Common Files\Rockwell\WFCU\wfcu.exe -I
"C:\Program Files\Common
Files\Rockwell\WFCU\FTH2HInterface.wfcu"
5. Press Enter.
The firewall is configured.