Rockwell Automation FactoryTalk Historian SE 3.01 Installation and Configuration Guide - Manual (Page 93)

Configuring FactoryTalk Historian Chapter 6
Rockwell Automation Publication HSE-IN024A-EN-E–December 2012 93
10. Select Enable data type filter to perform the search using the
default discovery rule.
NOTE
When you check the Enable data type filter option, the
auto-discovery mechanism will get all attributes that match the
name, UDT, and data type rule. When you leave the option cleared,
the mechanism will ignore the data type filter and only check the
name and UDT rule.
11. Click Next to begin discovering points. The Discovering
Historian Points dialog box displays the progress of point
discovery.
The discovered points are listed in the Confirm New
Historian Points dialog box.
12. Click Confirm Points to accept the search result.
13. In the New Historian Points Discovery Complete dialog
box, click Start. The FactoryTalk Historian SE server starts
collecting the discovered points.
14. Click OK.
You can view current and archive data using System Management
Tools. In this section you will learn how to:
• View current data (page 93).
• View archive data (page 94).
To view current data being collected by the FactoryTalk
Historian SE server:
1. Go to Start > All Programs > Rockwell Software > FactoryTalk
Historian SE > System Management Tools. The System
Management Tools dialog box appears.
2. Under Collectives and Servers, select the FactoryTalk
Historian SE server whose data you want to view.
Viewing Current and
Archive Data
Viewing Current Data