Rockwell Automation Logix5000 Control System: Connect Kinetix 350 Drives over an EtherNet/IP Network Quick Start User Manual
Rockwell Automation Equipment
Advertising
Table of contents
Document Outline
- Logix5000 Control Systems: Connect Kinetix 350 Drives over an EtherNet/IP Network Quick Start
- Table of Contents
- Preface
- 1 - Prepare the Kinetix 350 Drive Hardware
- Before You Begin
- What You Need
- Follow These Steps
- Prepare the Panel
- Mount the Kinetix 350 Drive
- Ground the Kinetix 350 Drive
- Disable the Safe Torque-off Feature
- Wiring Diagram
- Wire the IOD Connector
- Wire the Back-up Power Connector
- Wire the Input Power Connector
- Wire the Motor Power Connector
- Apply the Motor Cable Shield Clamp
- Wire the Motor Feedback Connector
- Connect the Kinetix 350 Drive to the EtherNet/IP Network
- Assign an IP Address to the Kinetix 350 Drive
- Additional Resources
- 2 - Add a Kinetix 350 Drive to an RSLogix 5000 Project
- Index
- Back Cover