Rockwell Automation 1787-GEN2SKIT, -2, -3, -4, -5, -6, -7 DeviceNet Starter Kit User Manual User Manual
Page 102
Publication DNET-UM003A-EN-P - August 2000
4-6 Build the Scanlist
If You Want to Use the .dnt File You Created in Chapter 3
If want to create your own scanlist and map the inputs and outputs,
you can either start from scratch by selecting File/New and going
online to display your network or you can use the file you created in
Chapter 3, follow these procedures:
1. In RSNetWorx, open the your .dnt file. If you are going to start
from scratch (File/New), you would click
to display your
network.
2. Double-click the scanner (node 00) on your DeviceNet network
to display the Properties dialog box. (You can also right click on
the device to bring up a menu and then choose Properties)
You see:
In Properties, you configure the scanlist to include the devices that
will be scanned on the network.