Rockwell Automation 1787-GEN2SKIT, -2, -3, -4, -5, -6, -7 DeviceNet Starter Kit User Manual - Manual (Page 56)

Publication DNET-UM003A-EN-P - August 2000
3-4 Connect Devices and Commission Nodes
Prepare to Add Nodes At this point you should have read and performed tasks in Chapters 1
& 2. Review your checklist from Chapter 1. You should have:
•
read about a DeviceNet network
•
identified, organized and secured what you need to use this
Starter Kit
•
located Rockwell Automation support services
•
assembled the KwikLink media
•
connected the ArmorBlock MaXum I/O base to the KwikLink
media and attached the seal block
•
connected and grounded your power supply
•
installed the scanner into your chassis
•
connected your interface
•
installed the required software drivers for PC cards
•
connected your PC
•
installed the Demo Version of RSNetWorx for DeviceNet