Rockwell Automation 1787-GEN2SKIT, -2, -3, -4, -5, -6, -7 DeviceNet Starter Kit User Manual - Manual (Page 40)

Publication DNET-UM003A-EN-P - August 2000
2-18 Construct Your Starter Kit
3. Connect the probe cable to the 1770-KFD interface module.
4. Connect the micro to conductor cable to the PLUG10R.
Most open-style devices ship with an open-style connector
included. These connectors are also shipped in packages of 10.
ATTENTION
!
Do not wire the 1771-SDN Scanner Module with the
network power supply on. Wiring the module with
the network power supply on may short your
network or disrupt communication.
jack screw jack screw
mechanical key
10-pin linear plug (open)
mechanical key
41708
Blue
Shield or Bare
White
Red Black
1787-PLUG10R
probe holes
1771-SDN,
1747-SDN, or
1756-DNB
probe
connection
micro to
conductor
cable
42034