Rockwell Automation 1787-GEN2SKIT, -2, -3, -4, -5, -6, -7 DeviceNet Starter Kit User Manual - Manual (Page 28)

Publication DNET-UM003A-EN-P - August 2000
2-6 Construct Your Starter Kit
2. Close the hinged assembly, apply pressure until the latch locks into
place.
3. Be certain that the cable is straight before moving on to step
four.
.
4. Tighten down the two screws at the center points of the hinge and latch
sides of the base; tighten down the latch side first. Take care to avoid
stripping, ample torque should be 5.56 N (15 in-lbs).
TIP
The latch has two catches.The first catch loosely holds
the connector on the cable. The second catch needs more
pressure applied to close the connector tightly. If the
cable is not in the correct position, the connector will not
close.
ATTENTION
!
Be certain that the cable is straight before tightening
the screws. Improper seating of the cable may cause
a weak seal and impede IP67 requirements.
30475
30492