Rockwell Automation 1787-GEN2SKIT, -2, -3, -4, -5, -6, -7 DeviceNet Starter Kit User Manual - Manual (Page 66)

Publication DNET-UM003A-EN-P - August 2000
3-14 Connect Devices and Commission Nodes
Commission the ArmorBlock MaXum I/O Module
You can set the node address with the rotary switches, RSNetWorx
,
or other software configuration tool. Valid node addresses are 00 to
63. Each module is shipped set for node address 63. The rotary
switches are located on the underside of the module.
The two switches are:
•
MSD (most significant digit)
•
LSD (least significant digit)
To reset the node address, use a small blade screwdriver to rotate the
switches. Line up the small black dot on the switch with the number
you wish to use.
The module is equipped with AutoBaud detect. AutoBaud lets the
module read the settings already in use on your DeviceNet network
and automatically adjust its data rate to follow those settings.
1. Set the node address with the rotary switches to 01 (under the
MaXum, marked “MSD”= 0 and “LSD” =1)
NODE ADDRESS
(00-63 PGM)
LSD MSD
0 1
2
3
4 5
8
9
7
6
0 1
2
3
4 5
8
9
7
6
Bottom View of Module
30703-M
Example: Node Address is set at 01, see small black dots.
Set LSD=1
Set MSD=0