Rockwell Automation 1787-GEN2SKIT, -2, -3, -4, -5, -6, -7 DeviceNet Starter Kit User Manual - Manual (Page 42)

Publication DNET-UM003A-EN-P - August 2000
2-20 Construct Your Starter Kit
3. Insert the card into the PCMCIA slot and slide it in until it is
firmly seated in the connector. Some computers have an ejector
button that pops out when the card is seated in the connector.
4. Connect the cable to the card.
Connect the 1784-PCD to Your Network for SKITs 2, 4, and 6
Follow these steps to connect the 1784-PCD to you network:
20718-M
20720
DEVICENET
1784-PCD
3. Wire the micro to conductor cable
to the PLUG10R and insert into the
scanner.
2. Connect the 1784-PCD1 cable to the probe cable.
Your laptop
1756-DNB,
1747-SDN, or
1771-SDN
42078
1. Connect the 1784-PCD1
cable to the card.
4. Insert the probe cable into the PLUG10R.
5. Insert the PLUG10R into the scanner.