Rockwell Automation 1787-GEN2SKIT, -2, -3, -4, -5, -6, -7 DeviceNet Starter Kit User Manual - Manual (Page 39)

Publication DNET-UM003A-EN-P - August 2000
Construct Your Starter Kit 2-17
Connect the 1770-KFD
for SKITs 1, 3, and 5 To connect the 1770-KFD interface module:
Refer to the installation instructions that are included with your
hardware for additional information. The driver for the 1770-KFD is
included in the RSLinx software.
1. Connect the RS-232 cable from the 1770-KFD to a serial port on
your computer.
2. Connect the RS-232 cable to the 1770-KFD interface module.
DEVICENET
42173
3. Connect the
probe cable to the
1770-KFD.
1. Connect the RS-232
cable to your computer.
5. Connect the probe cable from the
1770-KFD into the PLUG10R attached to the
1771-SDN, 1747-SDN, or the 1756-DNB
located in your processor chassis.
Your Computer
4. Connect the
PLUG10R to the
micro to conductor
cable.
2. Connect the RS-232
cable to the 1770-KFD