Rockwell Automation 1787-GEN2SKIT, -2, -3, -4, -5, -6, -7 DeviceNet Starter Kit User Manual - Manual (Page 41)

Publication DNET-UM003A-EN-P - August 2000
Construct Your Starter Kit 2-19
5. Connect the other end of the probe cable to PLUG10R and
insert into the 1771-SDN, 1747-SDN, or the 1756-DNB.
Install the 1784-PCD
for SKITs 2, 4, and 6 Use the 1784-PCD Installation Utility Disk that comes with the PCD to
install the PCD driver software. If the drivers are not installed, you will
not be able to select your interface in RSLinx.
The diagrams below show a PCMCIA 2.1-compliant system. If you use
a different computer, your installation may be different. See the
installation manual for your computer if you are not using a PCMCIA
2.1-compliant system.
1. Access the PCMCIA slot.
2. Grasp the card by the edges with the DeviceNet logo facing
upward and the 68-pin connector facing into the PCMCIA slot.
42103
IMPORTANT
You can insert or remove the card from a powered
or unpowered computer as long as the driver for the
card is already installed.
19869