Rockwell Automation 1787-GEN2SKIT, -2, -3, -4, -5, -6, -7 DeviceNet Starter Kit User Manual - Manual (Page 29)

Publication DNET-UM003A-EN-P - August 2000
Construct Your Starter Kit 2-7
5. Drive the IDC contacts into the cable by tightening down the two screws
all the way into the center of the base assembly.
6. Line up the keyed rectangular holes of the micro/open/terminator
connection interface with the matching posts on the base and snap the
micro module into place.
7. Secure the micro/open/terminator module by driving screws through the
two remaining mounting holes.
30476-M
Tighten screws by
the latch first
Check the cable
position before you
tighten the screws.
30477
Determine the exact
placement of the connector
before you engage the IDC
contacts
ATTENTION
!
Once the IDC contacts are
driven into the cable, the
module should not be
removed.