Skit6 also contains: skit7 also contains – Rockwell Automation 1787-GEN2SKIT, -2, -3, -4, -5, -6, -7 DeviceNet Starter Kit User Manual User Manual
Page 15
Publication DNET-UM003A-EN-P - August 2000
Before You Begin 1-5
SKIT6 also contains:
SKIT7 also contains:
1
The 1747-SDN works with an SLC™ 5/02, 5/03, 5/04, or 5/05
processor.
2
The 1771-SDN works with the PLC-5
®
family processors.
3
The 1756-DNB works with ControlLogix 5550 processors.
4
The 1784- PCIDS works with PC based control systems such as SoftLogix 5.
.
DeviceNet Scanner for ControlLogix
1
1756-DNB
DeviceNet PCMCIA Interface
1
1784-PCD
DeviceNet PCI bus interface/scanner
ControlPak CD-ROM
1
1784-PCIDS
4
You Must Provide:
1.PLC
, SLC 5/02, 5/03, 5/04, 5/05 or ControlLogix processor and software
2.PLC, SLC or ControlLogix chassis power supply
3.PLC, SLC or ControlLogix interface module (for PLC programming)
4.24V dc power supply (minimum 3A) that meets DeviceNet specifications.
Refer to the DeviceNet power supply specifications in publication,
DN-6.7.2, DeviceNet Cable System Planning and Installation Manual.
5.IBM
compatible PC with Microsoft
Windows
95/98 or Windows NT (NT
required for PCIDS) operating system
6.PC-to-SLC, PLC, or ControlLogix processor
1
1
Due to the varied possibilities, the components for your PC-to-processor communication link do not
appear in this table or the following illustrations. Your existing PC-to-processor connection is
compatible with this document’s procedures and configurations.
IMPORTANT
All SKITs are identical except for the scanner and/or
PC interface card used. This manual shows examples
using SKIT1 (w/SLC and 1747-SDN). Differences are
based on PLC processor technology (scanner
mapping and PLC processor programming). These
variations are described where applicable in this
manual.