Rockwell Automation 1787-GEN2SKIT, -2, -3, -4, -5, -6, -7 DeviceNet Starter Kit User Manual - Manual (Page 113)

Publication DNET-UM003A-EN-P - August 2000
Build the Scanlist 4-17
Map Input Devices
This screen shows how the inputs are mapped when RSNetWorx
automapped. Once you have edited the I/O Parameters for the
Inductive Proximity Switch, you will notice that the switch has taken
up all of word three and removed the RightSight Photoelectric Sensor.
The following are the modified Input mapping windows for each of
the Starter Kits. If you are going to map these devices to use with the
provided ladder logic you must be exact or the ladder will not run
properly.
SKIT1, for example:
•
The ArmorBlock MaXum needs the
two bytes of word 1.
•
The ControlTower Stack Light needs
to be mapped to the high byte of word
2.
•
The CompactBlock needs to be
mapped to the low byte of word 2.
•
The Inductive Proximity Switch needs
the two bytes of word 3.
•
The RightSight Photoelectric Sensor
needs to be mapped to the low byte
of word 4.
You will need to unmap the RightSight and the
Inductive Proximity Switch and then remap.
SKIT1 Inputs automapped