Rockwell Automation 1787-GEN2SKIT, -2, -3, -4, -5, -6, -7 DeviceNet Starter Kit User Manual - Manual (Page 26)

Publication DNET-UM003A-EN-P - August 2000
2-4 Construct Your Starter Kit
SKIT 7
Assemble the KwikLink Media System
Follow the figure below for placement of the KwikLink IDC taps and
the ArmorBlock MaXum base and seal block (2-9 through 2-12). Also
refer to the instructions that are printed on the outside of the IDC tap
package, and to the DeviceNet Cable Planning and Installation Guide
publication no. DN-6.7.2. Don’t connect any devices yet, you’ll be
doing that in Chapter 3.
I-0
A-0
I-1
A-1
O-0
O-1
Auxiliary Power
Network Status Module Status
0 1 2 3 4 5 6 7 0 1 2 3 4 5 6 7
Network Status
Module Status
CompactBlock I/O
1791D-888P 8 INPUTS / 8 OUTPUTS • DC POWER
Inductive Proximity Sensor
with micro cable
ControlTower
Stack Light
Standard Proximity Sensor with sensor
cable to ArmorBlock MaXum I/O
RightSight
Photoelectric Sensor
with micro cable
Your power supply
connected to an open
style tap
Your computer with the
1784-PCIDS
CDROM
42076
micro to
conductor
cable
CompactBlock I/O and PLUG10R with micro
conductor cable and two 24V insulated wires
PLUG10R
Terminator Terminator