Rockwell Automation 1787-GEN2SKIT, -2, -3, -4, -5, -6, -7 DeviceNet Starter Kit User Manual - Manual (Page 23)

1 Publication DNET-UM003A-EN-P - August 2000
Chapter
2
Construct Your Starter Kit
What This Chapter Contains Read this chapter to construct your Starter Kit, connect the scanner
and interface, install software, and properly ground the network
before setting up an online connection with your PC. The following
table describes what this chapter contains and where to find specific
information.
What Your Network Will
Look Like Refer to the illustrations below when you connect the devices your
DeviceNet network.
To: See page:
identify what your network will look like 2-1
assemble the KwikLink media system 2-4
install the ArmorBlock MaXum I/O 2-9
connect your power supply 2-14
ground your network 2-15
set up the 1771-SDN for SKITs 3 and 4 2-15
connect the 1770-KFD for SKITs 1, 3, and 5 2-17
install the 1784-PCD for SKITs 2, 4, and 6 2-19
set up the 1784-PCIDS for SKIT7 2-23
install the DEMO version of RSNetWorx 2-27