Metrohm tiamo 2.4 Manual - Manual (Page 1008)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
992 ￭￭￭￭￭￭￭￭
tiamo 2.4
Titrino: 702, 716, 718, 719, 720, 721, 736, 751, 758, 785, 794, 798,
799
pH/Ion - Meter: 867
Robotic Titrosampler: 855
Conductometer: 856
Appearance
The command has the following appearance:
Parameters
The parameters for the command MEAS T are configured on the follow-
ing 4 tabs:
￭ General/Hardware
Parameters for devices, sensors and stirrers.
￭ Measuring parameters
Parameters for setting the measurement procedure.
￭ Evaluations
Defining further methods for evaluating measurement curves.
￭ Additional measured values
Defining further measured values which can be saved as additional col-
umns in the measuring point list.
Command variables
The following command variables are generated in the method run by the
command MEAS T and can be used in formulas under the designation
'Command name.Variable designation':
Designation Description
.BP{x}.MEA Measured value (temperature) for the break point ×
(1…9) in the unit of the measured value
.BP{x}.TEM Temperature for the break point × (1…9) in °C
.BP{x}.TIM Time for the break point × (1…9) in s
.BSY Command status; 1 = BUSY, HOLD or ERROR; 0 =
READY; invalid (variable not available) = Command
has never been started
.DBL Total duration for the processing of the command in s