Metrohm tiamo 2.4 Manual - Manual (Page 1082)

5.6 Commands
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
1066 ￭￭￭￭￭￭￭￭
tiamo 2.4
[New]
Opens the Calc. measured value # dialog window, in which the param-
eters for the additional measured value can be entered (see Chapter
5.6.3.11.1, page 933).
[Properties]
Opens the Calc. measured value # dialog window, in which the param-
eters for the additional measured value can be edited (see Chapter
5.6.3.11.1, page 933).
[Delete]
Deletes the calculated measured value selected in the table.
Additional external measured values
Additional external measured values
on | off (Default value: off)
If this option is enabled, then a maximum of 3 new measured values can
be taken over and saved from existing measuring commands (i.e. MEAS)
which can also be displayed in curves under the designation Extern 1…3
and used in formulas as variables 'Command name.EX1…3'-
[New]
Opens the External measured value # dialog window, in which the
parameters for the external measured value can be entered (see Chapter
5.6.3.11.2, page 934).
[Properties]
Opens the External measured value # dialog window, in which the
parameters for the external measured value can be edited (see Chapter
5.6.3.11.2, page 934).
[Delete]
Deletes the external measured value selected in the table.
5.6.4.16 MEAS TMF
5.6.4.16.1 MEAS TMF - Overview
Dialog window: Method ▶ MEAS TMF ▶ Properties… ▶ MEAS TMF - 'Command
name'
Command for the measurement of the transmission factor. It serves
to adjust the 089 Photometer to 100% transmission. Distilled H
2
O is usu-
ally used.
Devices
This command can be executed with the following instrument:
Photometer: 089